Introduction: 5 Twigs
This installation consists of 5 found twigs that were three dimensionally scanned and then printed in translucent plastic. Each original twig was then mounted in opposition to its artificial counterpart.
Step 1: Scanning the Twig
Each of the 5 collected twigs were laser scanned.
Step 2: 3D Model
A three dimensional model was created from each twig scan.
Step 3: 3D Printed
The twig models were then printed in abs like translucent plastic.
Step 4: Display
Each of the 5 printed twigs were mounted opposite the original twig and displayed on the wall.
