loading

Cnc using ramps 1.4 ,repatier host,nema 17. Help with the software?

Hey guys I am almost ready with my CNC which I was building during my summer vacations.

Well I have nema 17motors ,ramps1.4 and polulu motor controller.

Well I can't get the firmware that is to be uploaded onto the arduino to work properly. I tried repatier/marlin firmware,but have no clue what to tweak and what not.

Are you building a CNC router or a 3d printer?

chrissunny94 (author) 2 years ago

well yeah I did,I even managed to test the steppers

A pic might help.

Did you designate the pin outs right?

Joe