How could I use an ordinary shopvac to connect up by my drill bit to clean up sawdust and metal shaving it creates?
3
answers
|
Answer it!
|
Nov 16, 2009. 6:15 PMdigitalbrad
says:
maybe a couple stiff wire coat hangers could hold the nozzel and then attach it do your drill press table, or to your hand drill. ORRRRR have a child and train him to hold a vacuum ( you can also train him to hold a flashlight. I was a very good flashlight holder when I was a child)
Nov 15, 2009. 5:59 PMRe-design
says:
Watch out for metal shavings and don't use this on a grinder. The metal gets hot enough to start a fire inside your vacuum.
 |
