Interfacing the nxt and rfid via the ardiuno?
I am having a problem here,I am to connect an rfid card reader to the arduino microcontroller and then the microcontroller to the nxt robot.From the researches that i have made i have learnt that the nxt communicates with the ardiuno microcontroller through I2C while the microcontroller itself reads data fom the rfid antenna using an UART bus.I am wondering if you could help on the code to make the arduino send a message to the nxt.
2
answers
|
Answer it!
|
Jan 24, 2010. 5:50 PMtsuki_yomi
says:
Both the Arduino and the NXT can use I2C so its possible to have the two communicate.
There is some code that allows the arduino to act as an NXT I2C sensor here:
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1262353163
It shouldn't take too much work to be able to what you want I would think.
There is some code that allows the arduino to act as an NXT I2C sensor here:
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1262353163
It shouldn't take too much work to be able to what you want I would think.
Nov 28, 2009. 9:59 AMTitanTechRobotics
says:
One option is to just get the rfid sensor for the nxt off of the lego education website. I got it and I am very impressed. As for making it work with an arduino, I am not much help, I don't have any experience with it, yet....
Hope this helps a little
P.S. maybe you should repost it so that it is a the top of the list again and more people see it.
Hope this helps a little
P.S. maybe you should repost it so that it is a the top of the list again and more people see it.
 |
