Speed control for a 24v to 250w wheelchair motor

 Speed controller for a 24v to 250w wheelchair motor.
Can anyone give me a list of parts needed to build  this also a  circuit board diagram showing where to put the components and the size of the PWM that would be required.
Thanking you all again.

sort by: active | newest | oldest
Take a look a the www.4qd.co.uk website, it really isn't worth trying to build your own.
MartinAM8 months ago

I use Sabertooth 2x25A for my RC Snow Plow.

See here: http://www.dimensionengineering.com/products/sabertooth2x25

priyan1438 months ago

help me plz

rickharris5 years ago
It may not even be necessary - on our electric racing car we used a simple on off button operating the motor via a relay - This works fine with the operator able to adjust speed by blipping the button
As a passing thought your motor may well draw 20+ amps and as much as 70 amps on start up from stationary so any system has to be able to cope with these currents.