What should the wires connect to if i took an RC Jet ski servo motor out of it ?
I recently took apart a RC Jet Ski. Within the Jet ski there was a servo for the rudder, a impeller to take out water that had been splashed in side and a motor with loads of wire leading to it, to drive a propeller (Jet ski's don't have propellers but this one does.
I Need to know what wire leading up to the RC servo motor do (green and brown). If I were to take the wires and use them on something else whhat shall I controll them with? My first thoughts were that sending an electrical current though the postive, would make it turn one way, and by the RC control, electrical currents could be past though postive and negative to make it turn left and right.