need all stepper motors and contoller, and power supply for diy cnc? suggestions?

Diy cnc complete and ready to connect to comp. Looking for everthing I need to run the machine
I was hoping for someone who had made a similar purchase that could reccommend a source

rich_moe7 years ago
Run along to the nearest Computer Recycle center and start ripping apart printers. The drive motors in any ink-jet or older dot-matrix printer is a stepper motor. At least, that's what I've heard.....
Modern printers don't contain motors man enough to run a CNC metal cutter.

Steve
Another place for small steppers are floppy disk drives.
This guy is very helpful
diycnc.co.uk/ for electronics
These guys are also good for the mechanicals
www.worldofcnc.com/

Steve