sort by: active | newest | oldest
JustXtreme (author) 7 years ago
 Hello All, 
Thank you for your responses, i used a 100 ohm 1/4 watt resistor. 
i'm using a 12v battery. 
It all seems to be working so far.
Thank You & Go Instructables!
Kinda sounds like a good cartoon superhero group. 
frollard7 years ago
forward power 80mw
forward current = 24mA

divide = 3.33 volts.
That was maximum power dissipation, which from your previous comment you would have to infer was at 75mA forward current, so Vf= 80/75 = 1 ish volt....

Too low IMHO - call it 1.2 V instead ? 

Steve
ah, touche.  Very few leds are that low...infrared?

Again, like you say - all depends on the voltage :D

b3v-250c googled gives me a first result of a 3-led array:
http://www.bluemelon.com/measureexplorer/me-led-b3v-250c;jsessionid=9F6B2ACAD2F633CED212BB5C38A8436F#photo-92108/T800600
You don't think this could have a resistor in it already do you ?
the 3 pack I found already does surely...otherwise it wouldn't be rated for 12v...


frollard7 years ago
...and you don't wanna run them at 75mA or they will be sad very fast.  12- (3*3.33) = 2 volt drop / .024

83.3 "or next higher' ohms resistor.

it will draw 2v * .024a = .048Watts, or 1/20th watt.  A very small power resistor would do.
Oops. Picked wrong line !
lemonie7 years ago
We're writing a FAQ for questions like this. Please look at this page and see if it answers the question
www.instructables.com/id/EG07LH2G4PBSPE2/step2/Questions-on-the-subject-of-LEDs-and-resistors/

L