Oodammo Light Assault Weapon
Well I built this one in a couple hours, i tried making a reliable Oodammo assault weapon that would use a minimum of pieces, because I am starting to run out, and I need a good assault weapon. It uses a slightly modified version of s0lekill3er's Oodammo Shotbow's magazine, so the mag is horizontal,I tried making it vertical, but it wouldn't work with the amount of ammo and the style I wanted in it. It gets decent range, I got it to shoot Oodammo about 25-30 feet, and it is very accurate. The magazine is removable, it isn't all that practical, but it will come off in a few seconds. The standard magazine capacity is 15, but that can we made bigger or smaller by replacing a few rods. Any criticism is appreciated and wanted, as long as it is constructive, I just tried making a small assault weapon, using Oodammo as a primary form of ammunition, and without using any black rods. The stock was thrown together rather quickly, and is only there for the firing pin guide
10
comments
|
Add Comment
|
sort by:
active |
newest |
oldest
Oct 16, 2009. 5:34 PMWafflicious
says:
I put that mag on the one in my slideshow 100x more reliable thanks for leading me to the mag!
Oct 16, 2009. 8:18 PMWafflicious
says:
OK! I'm making a sideshow tomorrow if you need other pictures too.
Oct 17, 2009. 6:12 AMShadowChaosControl (author)
says:
does it require a black rod for the firing pin? it is the one thing making me stick to slingshots, and i'm glad this mag is more reliable than mine, mine was crap
Oct 16, 2009. 5:44 PMWafflicious
says:
I just had an idea. I put a block trigger on the magazine so the pin locks back so you can load it.
Jul 24, 2009. 7:21 PMknexsuperbuilderfreak
says:
i was gonna say you took solekillers desigan but it only on side and like dj said try and move the trigger back
Jul 8, 2009. 2:42 PMTwistedParadox
says:
You could try to structure the back more, it looks very flimsy.
Jul 8, 2009. 3:23 PMShadowChaosControl (author)
says:
the stock was literally just so the pin guide wouldn't bend, i put no effort into it
 |
Vancouver Mini Maker Faire 2012
Rebuilding NordicTrack ski machine drive rollers
Looking for New Zealand-based Instructables authors for conference on August 27 in Wellington
Call to makers - Brighton Mini Maker Faire
Milk Crates - not as green as you think
TEDxBaghdad - Iraq - violence, dust storms and open sourced manufacturing
UK Mini Maker Faire - The Derby Silk Mill - New Poster to Share!
