What are the basic tools I need?
I have a list of the basic tools I will need for this. If you can add anything that would be great.
1.LEDs
2.Wire
3.Duck Tape
4.Soldering Station
5.Persision Screwdriver
6.Razor Knife
7.O-Rings
8.Springs
9.Batterys
10.Needle Nose Pliers
11.Clamps
12.Screwdriver
Any other suggestions would be great.
Thanks.
6
comments
|
Add Comment
|
sort by:
active |
newest |
oldest
Sep 3, 2008. 2:26 PMkenn123
says:
heat gun shrink tube (nice not necessary) electrical tape ...and a good idea or two is helpful
What are you planning to make? Or is this a general list? If it's general, you need general tools - hammer, nails, saws (including hacksaws) files, rasps, big lumpy screwdrivers, screws, glue-gun, drill, dremel, etc.
Aug 20, 2008. 6:25 AMguyfrom7up
says:
In adition: Solder (duh) helping hands or a PCB clamp resistors for the LEDs springs arn't used that much you just need one good cheap small philups head and a flat head for prying instead of batteries you can just use wallwarts for most projects, as they don't need batteries. ummmm.. something important but I just forgot, ha
Aug 20, 2008. 6:13 AMLftndbt
says:
Nup, looks like their all there. Sorry I can't find what we are talking about.
 |
Vancouver Mini Maker Faire 2012
Rebuilding NordicTrack ski machine drive rollers
Looking for New Zealand-based Instructables authors for conference on August 27 in Wellington
Call to makers - Brighton Mini Maker Faire
Milk Crates - not as green as you think
TEDxBaghdad - Iraq - violence, dust storms and open sourced manufacturing
UK Mini Maker Faire - The Derby Silk Mill - New Poster to Share!
