loading

Wiring, DSC PC1832 security system at home, how?

http://www.nlcpr.com/images/PC1832_lr.jpg

Hey, hope somebody can help me to getting this thing work properly, im not sure how to connect the keypad, smoke and move detectors... i got 3 zones to move detectors(means that in one floor i got all detectors joint on one wire, and now, where on that board i put red and black(+12 and -) yellow and blue(NO and C) That picture is not my taken, found it on inthernet. Thanks for any help:) Sorry for my bad english.

sort by: active | newest | oldest
Punkguyta7 years ago
Well if you can find me the Model numbers off the enclosure/board and the MAKE/Brand of the system that would be a start.
blackrock112 (author)  Punkguyta7 years ago
Thanks! PC1832 V4.23 EU UA503 is on the board and PIR Motion Detectors are named DSC- LC-100PI(got seven terminals, but im using only 4, NC, C and -12V+) If anything is still missed then ask for it, hope thats gonna help u to understand what u need to teach me:)
blackrock112 (author)  blackrock1127 years ago
http://www.flickr.com/photos/50966597@N07/4682951783/  Finnaly got some pictures uploaded, got really slow connection here:( Hope now somebody can help me, where to connect the sensors wires:) I got now in all floors one terminal- 1. 2. and 3. first floor detectors are joint gradually, and other too, so now i need to install them on that board, and smoke detectors too. Sorry if its wery confused, but i give my best to explain...
Oh jeeze.. I see your debacle going on here... This is almost one of those things that unless I sat down with a laptop and had that box right infront of me with the tools to wire it up, I'm not sure I could tell ya, I'll read around though and see if I can make sense of it. Maybe I'm just not awake-enough this morning.
blackrock112 (author) 7 years ago