Print PDF
Favorite
Email
Step 15Repeat Yesterday
Now it's time to:
1. Wax (don't forget the flange)
2. Apply PVA
3. Apply "Gel Coat"
4. Apply Resin
5. Apply Glass Mat and Resin
6. Clean Up
The same exact thing as yesterday - except the tool isn't so close to the ground anymore.
So your tool shrunk a little
Look at that picture -- it looks like our tool shrunk a little below the waterline. This exposes a curve greater than 90 degrees (uh oh). The solution - prop it up as much as possible (as shown) and then apply a thick coat of the "gel coating" to this edge to make up the difference. Otherwise, our tool will break when we try to separate.
1. Wax (don't forget the flange)
2. Apply PVA
3. Apply "Gel Coat"
4. Apply Resin
5. Apply Glass Mat and Resin
6. Clean Up
The same exact thing as yesterday - except the tool isn't so close to the ground anymore.
So your tool shrunk a little
Look at that picture -- it looks like our tool shrunk a little below the waterline. This exposes a curve greater than 90 degrees (uh oh). The solution - prop it up as much as possible (as shown) and then apply a thick coat of the "gel coating" to this edge to make up the difference. Otherwise, our tool will break when we try to separate.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
