Introduction: " I Love Batman " Key Chain

Picture of " I Love Batman " Key Chain

I've been a Batman fan since I was 7-years-old. This started when I watched the movie " Batman : Begins " From that day I became his utmost fan. The only reason I am his fan is that Batman doesn't have a super power. He's not an alien or meta human. He doesn't have any high-tech suit that makes him fly. He is just a human. His real name is Bruce Wayne, a rich guy who chooses to dedicate his life for protecting the people of his city. He choose to give his life for beating up bad guys who threaten Gotham City.

He is the Bat of Gotham. He is Night. He is BATMAN !

Here is one of my creation that I have made recently, a wooden "I Love Batman" Key Chain by Burning Wood.

Here is one of the most easy and fast method of making a Key Chain by Burning Wood.

Step 1: Things Required

Picture of Things Required

Tools Required :

  • Hand Saw
  • Firmer Chisel
  • File
  • Drill Machine
  • Soldering Iron
  • Screwdriver
  • Mallet
  • Sandpaper

Material Required :

  • 3 Wood Pieces of almost equal size (you can use any type of wood)

Step 2: Chiseling and Filing

Picture of Chiseling and Filing

Chisel the wood pieces to make them of almost same size. Then with the help of a sandpaper give it a good finish. Make the edges curved.

Approx. size- 30 mm * 20 mm

Step 3: Drilling

Picture of Drilling

With the help of a hand held drill make holes in the wooden pieces. Remember to make 2 holes on one piece , 4 holes on second and three holes on the third piece.

One hole of the third piece is bigger than the other two. This hole is used for adding a ring to connect the key.

Step 4: Drawing

Picture of Drawing

Draw the following figures on the three wooden pieces with pencil.

Step 5: Engraving

Picture of Engraving

Engrave the markings with the help of a screwdriver.

This engraving makes it easier to use a soldering iron on the wood pieces.

Step 6: Burning

Picture of Burning

Burn the wood with the help of a soldering iron. The type of soldering iron that I used had a pointed tip.

Thus marking became easy.

Step 7: Joining

Picture of Joining

Join the three pieces with the help of a wire. Add a ring at the bigger hole so that a key can be easily added.

Step 8: Completion

Picture of Completion

Your " I Love Batman " Key Chain is ready !

Comments

About This Instructable

151views

2favorites

License:

More by Hardik Longakshi:" I Love Batman " Key ChainDIY Wooden ClampSand Paper Block
Add instructable to: