Print PDF
Favorite
Email
Step 3Putting it togeather
looking on top of the shoe it should have 2 bumps like this | | .. place super glue in this than center and place one of your level tubes on that and hold it down until it drys ... it will automatically be held horizontally perfectly
fill the bottom of one of the tubes and put superglue on it before the glue drys and smush (with lack of a better word) it on the shoe ON THE FRONT END AND CENTER (lining it up with the center lines on the vertical tube)
NOTE: it should be placed on the front side of the shoe facing where the lens would be
put hot glue on the top and super glue as before on the same tube and quickly place it on the table and carefully line the last tune up so its perfectly aline using the 2 striped on the horizontal tubes
NOTE: if you do the way shown you will still be able to use the built in flash
fill the bottom of one of the tubes and put superglue on it before the glue drys and smush (with lack of a better word) it on the shoe ON THE FRONT END AND CENTER (lining it up with the center lines on the vertical tube)
NOTE: it should be placed on the front side of the shoe facing where the lens would be
put hot glue on the top and super glue as before on the same tube and quickly place it on the table and carefully line the last tune up so its perfectly aline using the 2 striped on the horizontal tubes
NOTE: if you do the way shown you will still be able to use the built in flash
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
