loading
Picture of 123D Space Shuttle
Untitled2.jpg
IMG_1541.JPG
IMG_1545[1].JPG
IMG_1544[1].JPG
IMG_1543[1].JPG
This project is a good introduction to using 123D Make. 123D Make is a software that will allow you to turn any stl file into puzzle like cardboard slices. I have included a  zip file with all the pdf, stl and 3dmk files for this project.  
 
Remove these adsRemove these ads by Signing Up

Step 1: Tools and Materials

​Tools and Materials
  • Cardboard 
  • Wheat Paste 
  • Laser Cutter or Exacto Knife and Printer 
  • Paint
  • Optional: Nails and Plywood 
  • 123D Make

Step 2: Using 123D Make

Picture of Using 123D Make
Untitled3.jpg
Untitled4.jpg
Untitled5.jpg
First download and extract the zip file.  The default size is for a 29 cm long shuttle.  If you want to change the size, launch 123D Make and open Body.3dmk.   Type the  desired dimensions in the object size box. Then open all the other .3dmk files and increase all the other object sizes by the same amount.  After that click the "get plans" button and select file type, then click Export.          

Step 3: Cutting

Picture of Cutting
IMG_1513.JPG
IMG_1514.JPG
IMG_1515.JPG
IMG_1516.JPG
IMG_1517.JPG
IMG_1518.JPG
IMG_1519.JPG
If you are using a laser cutter set it so that it cuts through on the blue lines and just etches the red lines. If you are hand cutting, print out the pdf and glue them to cardboard, then cut them out with the Xacto Knife.    

Step 4: Gluing

Picture of Gluing
IMG_1520.JPG
IMG_1522.JPG
IMG_1524.JPG
IMG_1525.JPG
IMG_1526.JPG
IMG_1527.JPG
IMG_1528.JPG
IMG_1529.JPG
IMG_1534.JPG
IMG_1531.JPG
Untitled8.jpg
First, assemble all the layers of the main body. Now put layer 3 on the plywood and hammer  6-10 nails around it to use as  guide.  Apply glue to the bottom of layer 4 and using the guides put it on top of layer 3. Repeat this step until layer 20. Afterwords put a weight on it and leave it to dry. Glue together the tanks using the same procedure. While it is drying, glue the wings, layers 1 and 2 , together. When they are both dry, glue them together by lining up the body with the guide lines on the wing.  Next, insert the rudder into the slot at the back of the body and glue.  Finally, glue the nozzles together, following the assembly directions in 123D Make.                    
Chef Somer2 years ago
This is absolutely amazing!
I like the tanks you made, this was a nice use of 123D
86 (author)  audreyobscura2 years ago
Thank You!