Introduction: 16 Channel Servo Controller (Raspberry Pi)

Picture of 16 Channel Servo Controller (Raspberry Pi)

How to control multiple servos using a 16-Channel driver with the raspberry pi.

*NOTE: Servo Controller input voltages should be 5-6 volts instead of the suggested 9 volts

Step 1: Parts

RPI 3 –

4 Amp Power Adapter –

16GB Micro SD –

16-Channel Servo Controller:

6 x 1.5V AA Battery Holder:

5.5×2.1mm Male+Female DC Power Socket:

120 pcs jumper cable:

9g Servos:

Step 2: Setup


About This Instructable




Bio: the Raspberry Pi is Awesome!
More by piddlerintheroot:Accelerometer (Raspberry Pi)Flame Sensor (Raspberry Pi)Soil Moisture Sensor (Raspberry Pi)
Add instructable to: