Introduction: 1x1x2 Rubik's Cube
In this Instructable I am 3d printing a 1x1x2 Rubik's cube that I designed in 123D design, using my Ultimaker 3.
Step 1: Modeling
I made this design using 123d design.
The file can be found at the link below.
Step 2: Printing
I printed it using Gizmo Dorks black ABS filament on my Ultimaker 3 3d printer.
Step 3: Cleaning Up and Sanding
1- Remove excess material using sharp scissors.
Step 2- Use sandpaper to smooth any sharp edges
Step 4: Smoothing
use a cheap paintbrush to paint a player of acetone over the entire surface and allow it to dry.
Step 5: Stickering
Just put Rubik's cube stickers on the 1x1x2 with red opposite orange, blue opposite green, and yellow opposite white.