Introduction: 2 X 12v (24v) Power Supply 2X12V ISPRAVLJAČ

This is process of making 2x12v power supply. I will use this psu for my ZVS driver .

watch my videos !!!

Step 1: Parts

Picture of Parts

Step 2: Making Holes for Fuse and 220v Input

Picture of Making Holes for Fuse and 220v Input

Step 3: Mounting Parts Into Box

Picture of Mounting Parts Into Box

Step 4: Drilling Holes for Output and Wiring

Picture of Drilling Holes for Output  and Wiring

Step 5: Finish

Picture of Finish

Comments

russ_hensel (author)2017-01-10

Good start. Some things to think about adding:

* schematic

*on off switch

*power indicator light

*some filtering ( so dc does not pulse )

*some regulation

*ZVS may not need some of above, but then what is ZVS: google suggest several different things

Zierer Visa Service ZVS - Travel Services - Two Greenway Plaza ... could be one of them.

ELECTRONICS3 (author)russ_hensel2017-01-29

this is 30minute project (or less) I needed psu for zvs driver becouse I burned my 3600W lab psu whit high frequency and big voltage :( I will make better psu with all that !!!! thx

Swansong (author)2017-01-10

This looks neat :) Just for reference if you would like to break down the steps into written instructions along with the progress/step photos so that others can replicate your projects then it will receive more attention from the community and be possible to be featured on the site. https://www.instructables.com/id/How-to-Create-a-Fe...

ELECTRONICS3 (author)Swansong2017-01-10

thx

About This Instructable

364views

3favorites

License:

More by ELECTRONICS3:2 x 12v (24v) power supply 2X12V ISPRAVLJAČ ZVS Driver : Jacobs Ladder and Flyback Powering 12v LED on Excess Power
Add instructable to: