Introduction: 3D Cookies
A friend had a "Dead Rock and Roll" theme Halloween party last Saturday evening. Everyone had to come dressed as there favorite dead rockstar. I was asked to bring something sweet to eat, so with all the hype over 3D movies these last couple of years, I wanted to make a special yummy treat that would have that 3D magic. You can use any rubber stamp image to make these cookies. It was so easy to make and it was a huge hit at the party! Everyone was walking around with their 3D glasses on eating the 3D rock and roll cookies - it was so much fun!!!!
Step 1: Supplies
What you will need to make theses cookies
red gel food coloring
blue gel food coloring
4x4 inch piece of felt
cookies - I used round ginger cookies
smaller round cookie cutter
Step 2: Rolling Out the Fondant
Roll out your fondant on a clean surface. Once you get a nice size of the rolled fondant use your round cookie cutter and cut out as many round pieces you can.
Felt - this piece will be your stamping pad that you will put the gel food coloring on. You will need 2 pieces of felt - 1 for the red and 1 for the blue. Make sure you have enough gel on the pad to cover the image of your rubber stamp. Be careful to only get the gel on the image not on the negative space. It can make the cookie have a "ugly" spot.
Using your blue food coloring gel pad pick up some ink on your rubber stamp and press the image to the prepared round pieces of fondant. Do all your pieces of fondant because you are going to clean your stamp with soap and water to get it clean for the next color.
Step 3: Adding the Red Stamp
Now that you have completed the blue stamp and you have cleaned you rubber stamp it is now time to stamp the red gel food coloring. With you second piece of felt add the red food coloring as before with the blue. Use your clean rubber stamp to pick up some of the red food coloring and stamp all little off from the blue image to get the traditional "3D" look. Complete all of your round fondant pieces.
Step 4: Adding to the Cookie
Once you have finished all the pieces of fondant with the 2 colors you can now add it to any cookie of your choice. I used ginger snaps and with a little white icing that comes in a can put a small dot in the center of the cookie that will be the "glue" that will hold your 3D fondant rounds to your cookie.
Add your 3D glasses and then your ready to go!!!!!!!