Print PDF
Favorite
Email
Step 6Wrap it up.
Turn the pad over and place on the Rip-Stop nylon. I also added a thin strip of padding on the aluminum strips so it cuts down the noise when it strikes the frame bars. You can see the terminals where the Ground and controller wires will attach.
Staple the nylon to the plywood. Leave enough room at the top of the aluminum strips for the velcro to come straight out so it can wrap around the frame bar.
The wrap should be firm, but not too tight. There has to be some give for enough motion to release the pressure button when not being pressed.
Staple the nylon to the plywood. Leave enough room at the top of the aluminum strips for the velcro to come straight out so it can wrap around the frame bar.
The wrap should be firm, but not too tight. There has to be some give for enough motion to release the pressure button when not being pressed.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
