Introduction: 3D Origami (Hexahedron & Cube)

Step 1: Regular Square Piece of Paper

Step 2: Fold Paper in Half and Then Unfold

Step 3: Fold the Half of the Right Side of the Paper in Half and Unfold

Step 4: Fold the Half of the Left Side of the Paper in Half and Unfold

Step 5: Fold the Top Right Corner of the Paper and Make the Triangle Flesh With the Crease

Step 6: Fold Along the Dotted Line to Make It Flesh With the Crease

Step 7: Fold the Right Side of the Half of the Half Over to Meet the Middle Crease

Step 8: Rotate Paper 180 Degrees

Step 9: Fold the Top Right Corner of the Paper and Make the Triangle Flesh With the Crease

Step 10: Fold Along the Dotted Line to Make It Flesh With the Crease

Step 11: Fold the Right Side of the Half of the Half Over to Meet the Middle Crease

Step 12: Fold the Top Left Corner Along the Dotted Line and Put Under the Flap

Step 13: Rotate Paper 180 Degrees

Step 14: Fold the Top Left Corner Along the Dotted Line and Put Under the Flap

Step 15: Flip Paper Around

Step 16: Fold Along the Dotted Line and Make the Edges Flesh With Each Other

Step 17: Fold Along the Dotted Line and Make the Edges Flesh With Each Other

Step 18: Repeat 2 More for Hexahedron (5 for Cube)

Step 19: Take One Corner of Paper and Insert It Underneath the Flap

Step 20: Take the Other Corner and Put It Underneath the Flap That Your Able To

Step 21: Open It Up a Little to Make a Cup Shape

Step 22: Insert the Other Corners in the Flaps With the Last Paper to Form the Hexahedron

Step 23: Hexahedron Done!

Step 24: Insert One Corner Under the Flap

Step 25: Grab Another Paper and Inset That Corner Under the Flap

Step 26: Take the Bottom Corner of the Far Left Paper and Put It Under the Flap of the Bottom Paper to Make a Cup Shape

Step 27: Add Another Paper to Make the 4th Side

Step 28: Add the 5th Side

Step 29: Insert the Last Paper Under One Flap

Step 30: Insert the Corner Under the Flap on the Other Side

Step 31: Insert the Last Two Corners Under the Two Flaps

Step 32: Cube Done!

Any questions, just comment!

Comments

About This Instructable

3,069views

11favorites

License:

Bio: Studying Electrical Engineering at Iowa State University.
More by BioSteam:3D Origami (Hexahedron & Cube)Origami Lotus FlowerOrigami Deli Hat
Add instructable to: