Introduction: 3D Printed Double Wall Light

Two directional wall lamp for GU10 fixtures for use with low heat LED Bulbs. Printed in Glow in the dark Blue.

Step 1: Print Parts:

http://www.thingiverse.com/thing:854129

Point the cone up & remember to print 2. Feel free to modify this.

Step 2: Wiring:

Wire Each lamp cone. Fits snug.

IF YOU DON'T KNOW HOW TO WIRE A WALL LAMP THEN DON'T.

Step 3: Piece Together & Enjoy.

Only use LED Bulbs. Write this on the inside of the print.

Comments

author
tomatoskins (author)2015-05-29

That's a fun little light! Thanks for sharing!

About This Instructable

1,310views

40favorites

License:

More by ewanoncadd:3D Printed Double Wall Light
Add instructable to: