3D Printed Holder for IKEA FRÖER Flowerpot

Published

Introduction: 3D Printed Holder for IKEA FRÖER Flowerpot

About: DIY in general, woodworking and electronics enthusiast.

This is a super simple project, consisted in making a piece to hang in the wall the pots provided by the "FRÖER Herb Growing Set" from IKEA. I have used my brand new 3D printer (recently built kit from gearbest.com).

Step 1: Design

The part has been drawed in the student version of Solid Edge ST8. The diameter of the hole of the hanger must be 86mm. The hanger is atached to the wall using double sided adhesive tape.

Step 2: Printing

Step 3:

I wiped the surface with rubbing alcohol before adhering the hangers.

Step 4: File

Share

    Recommendations

    • Pets Challenge

      Pets Challenge
    • Stick It! Contest

      Stick It! Contest
    • Make it Move Contest

      Make it Move Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    2 Comments