3D Printed Rubber Band Powered Car

588

7

1

Posted

Introduction: 3D Printed Rubber Band Powered Car

Step 1: Post-Printing

With a small wire, I fold it, I warm it with a lighter and I nail it little by little.

Step 2: Printing Configuration.

For the printing of the axes I recommend a density of between 80 and 100% and a very good bed calibration. For the chassis, the wheels and the spoiler I recommend not to use supports.

Share

Recommendations

  • Epilog Challenge 9

    Epilog Challenge 9
  • First Time Author Contest 2018

    First Time Author Contest 2018
  • Sew Warm Contest 2018

    Sew Warm Contest 2018
user

We have a be nice policy.
Please be positive and constructive.

Tips

Questions

Comments

So tempted to buy a 3d printer for myself.