Introduction: 3d-printed Tile Mount to Lift Up IKEA Ordning Drainer From Bench

This is a remix-joining of:
http://www.thingiverse.com/thing:811665
http://www.thingiverse.com/thing:923217

This uses the suction-hook from IKEAsStugvik serie, http://www.ikea.com/se/sv/catalog/categories/serie... IKEA claims it's rated for 3kg/6.6lb - http://www.ikea.com/se/sv/assembly_instructions/st...

Some notes:

I didn't have the common sense to write down the printer settings - sorry about that!

This copy was printed in PLA (Miami Hot Pink Deluxe: Semitransparent!) with rafts and needed an hour or so to remove and trim away extra material to make a good fit. A test copy printed in ABS with rafts fitted without trimming, ymmv.

Printed at #sliperiet #fablab in Umeå, Sweden!
https://www.facebook.com/fablabumea/?fref=nf
http://sliperiet.umu.se/sv/fablab/

Enjoy and happy dishwashing!

Comments

author
wold630 (author)2016-04-15

This is a great idea!

author
_prry (author)wold6302016-04-15

=) Thank you, thank you very much!

About This Instructable

107views

4favorites

License:

More by _prry:3d-printed Tile Mount to Lift Up IKEA Ordning Drainer From BenchLaser cut and etched enclosure for 70x50mm circuit board
Add instructable to: