Introduction: 3d Printed & Laser-engraved Iphone 5c Case

By

At first, I downloaded an iphone 5 case off of thingiverse.com, forgetting that the two phones have different contours on the back. Well after after wasting an hour printing, I immediately started to design my own. I have attached the STL file, it is thick & durable, and nearly a perfect fit..unlike the ones  I seen on line. I should have used the flat side of the platform...now I have the stupid makerbot logo all over the case

Makerbot settings: 240 degrees, 20% infill, 0.15mm line height, 200mm/s for travel and extrusion. no rafters, only supports.

Epilog laser settings: Raster image at with 100% speed, 60% power.

THIS INSTRUCTABLE WAS MADE AT TECHSHOP IN Allen Park, MI (Detroit)
www.techshop.ws

Attachments