50,000 volt etch-a-sketch!

Step 7 All glued together!

  Now that your trolley is finished, its time to attach it to the carrage assembly. This is pretty simple, just take your finished assembly, and set it on top of your carrage, and make sure it is lined up in the middle, and glue it in place. Pretty simple.

 Apparently, I neglected to take a single picture of the trolley assembly completed, without the servo attached lol, so ignore the servo for this segment =)
 anyways, it should look like this when mounted, again sorry for the bad picture, apparently out of 600 of them, I forgot to take a few lol.