Print PDF
Favorite
Email
Step 2Modding the PS3 sled02
The three holes circled in red below need to be drilled out to 5.0mm dia.
Saw the beam splitter section off, cut along the green line.
Cut out the turning mirror holder marked in purple.
It is best to put the small cover plate back on over the beam splitters to keep them clean (not shown).
Saw the beam splitter section off, cut along the green line.
Cut out the turning mirror holder marked in purple.
It is best to put the small cover plate back on over the beam splitters to keep them clean (not shown).
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
