Print PDF
Favorite
Email
Step 3Wiring the LEDs
Step 3: Wire the LEDs and glue on the lens holders
A. Wire stars together (two small red wires) between + and - tabs.
B. Drill another hole in back bezel for incoming power. Add shrink tubing for strain relief on each side of bezel.
C. Drill holes in base of lens holders to route black negative power wire.
D. Glue lens bases to stars, preferably with Loctite 460 superglue.
E. Solder incoming power wires to stars (white + and black -).
A. Wire stars together (two small red wires) between + and - tabs.
B. Drill another hole in back bezel for incoming power. Add shrink tubing for strain relief on each side of bezel.
C. Drill holes in base of lens holders to route black negative power wire.
D. Glue lens bases to stars, preferably with Loctite 460 superglue.
E. Solder incoming power wires to stars (white + and black -).
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
