deconstruction round means that a pin pushes a bullet out of a clip, and the clip 'shoots' the bullet.
Step 1: The "barrel"
1,2. make this part
3. gather two white rods and connect them
Step 2: Ammo wheel
make these parts
Step 3: Build and make connections
these parts are a little hard to connect.
Step 4: The handle
make the handle
Step 5: Add the handle
Step 6: Make this thingy
make this thingy
Step 7: Make the barrel
make the barrel
Step 8: Make this part
make the top of the gun
Step 9: The only rubber band
add the only rubber band, sorry if this part is confusing
Step 10: Add this part
this is just to make it look better
Step 11: Little side panels
these are little side panels, you dont need them, it does look better though.
Step 12: Ready, aim, fire!
to fire the gun, pull back the handle and watch that bullet fly...
and fall back to the ground two seconds and five feet later.
make sure that a bullet is always i the middle of the barrel, even if you need to hold the revolving wheel in place.