8x4=2 (2 Tables from 1 sheet of plywood)

Step 3 Admire your new table

If you want to add additional rigidity the table top can be screwed through to the edge ply of the leg frames. Use the lotted holes as a guide for where the legs are beneath and drill a small diameter locating hole through from above before countersinking a posi-head woodscrew.

If you like this table you might like other things I do....

barnaby gunning architects

Comments

[richardsan]

you could cut into the tabs with a very slender v and cut wedges to fit those slots, tap them in from the top. that will tighten up the leg support. and i think i'd dress up the 'toes' on the bottom of the legs, they will need protection. there's all the weight right down there on the floor plane. maybe soak in some epoxy or cap them.

[gosub]

Not easy to cut by hand but excellent design for building a cheap table. The cuts needs to be painted or something.

[static]

Hand tools power or otherwise, or a combination there of, should be sufficient to build this project. IMO the contrast of the unfinished edges on the black table look great, but no so much on the white table. Anyway one can finish to their own taste, to state the obvious. :)

[GTecb]

Very good idea! Thank you and good luck!