Print PDF
Favorite
Email
Step 5Soldering
After step 2-4 you'll need to solder the parts to the perf board to make your detector usable.
If you're a first-time solderer, you should watch this video: http://www.youtube.com/watch?v=I_NU2ruzyc4 .
(I didn't make the video, thanks go to CuriousInventor)
After soldering, your project should look like the example in the first picture.
Then, clip off the excess component leads, making sure not to break the solder joints.
If you're a first-time solderer, you should watch this video: http://www.youtube.com/watch?v=I_NU2ruzyc4 .
(I didn't make the video, thanks go to CuriousInventor)
After soldering, your project should look like the example in the first picture.
Then, clip off the excess component leads, making sure not to break the solder joints.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
