A Knex Gattling Gun: THE RAPENATOR88

1,158

1

7

Published

Introduction: A Knex Gattling Gun: THE RAPENATOR88

This is my new knex gun and my First of many instructables. its mainly for looks but if your motor is strong and your rubber bands are stronger then its deadly! ENJOY!!

Step 1: Part List-(=

'Connectors:'

White:20

Yellow:60

Green:18

Red:28

Grey 2-Slot:2

Grey 1-Slot: 30

Orange:16

Purple 3-D:70

Blue 3-D:21

'Rods:'

Grey:3

Red:2

Yellow:45

Blue:40

White:40

Green:72

'Misc. Stuff:'

Black Y Clip:2

Tan clip:4

Blue Clip:1

Grey Spacer:8

Blue Spacer:2

!NOTE! THERE MAY OR MAY NOT BE EXTRAS BUT BETTER HAVE MORE THEN HAVE TO STRAIN URESELF IN THE MIDLE OF BUILDING TO DIG IN YOUR BIN OF GOODIES FOR 1/2-AN HOUR!

Step 2: The Barrel Part

The part that spins and shoots. srry theres extra photos im trying to post this ASAP

Step 3: The Back Supporters

The Part the holds the gun togeather

Step 4: The Middle Supporter

que senior? que haces habla?

Step 5: Some Miscilanious Shit

wazzup?!

Step 6: Loading

This gun uses Green or White rods to shoot. you just cock it an pull it.

Share

    Recommendations

    • Water Contest

      Water Contest
    • Stick It! Contest

      Stick It! Contest
    • Oil Contest

      Oil Contest

    7 Discussions

    If that were used for K'nex wars or etc it'd better be able to snipe (I mean with a good rubber band of course) because it is so big and obvious that you'd get your seen pretty easily. I see a motor, in it, though; I'll hope it can shoot on its own so you can run away from it, as it mauls your opponent.

    when it shoots does it shoot by itself or do you have to put your hand out and let it shoot out?

    Well I have to say this one is better looking then others it still can't fire very well and because this is my first instructables I didn't know about picture uploads n stuff

    There are too many of these on the site. Each one a polished version of the previous gatling.