Instructables

A Painting with a Twist

Step 4: Drilling Holes

Picture of Drilling Holes
The next priority in the creation of this project was to drill a couple hundred tiny holes into the PCB. This can take a bit of time and can be a little frustrating. Pretty much, I just scattered them randomly, but I tried to get an even number of holes in a "cluster" just so that I don't have to worry about trying to stretch a wire too far. Once all of the holes are drilled, the next step is to pass the nodes through the holes.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!