A SciFi Scanner/Ray Gun movie prop

Step 7 SOLDER!!!!!1!!!11!!!!!!!111!!!1!11!!!!one!!!!!2!!

here's where your knowledge of electronics comes in. dig your circuit plan out. remember that little old thing WAAAYYY back in good old step 1? well now its time to use it. basically solder your positive lead to any one LED in series with your switch and pot to the positive side of your battery and run the negative wire straight back to the negative side of the battery. do basically the some with your other components (plus or minus a pot or tilt switch) with motors polarity (negative or positive) does not matter. insulate all your unprotected (insulation-less) soldering points with shrink tube (not counting terminals).