Introduction: A Simple Clap Switch Using 3 Different Circuit Modules

This project has been taken from buildcircuit.com. The following schematic and circuit layout show a simple clap switch.
The project has been made up of 3 different and independent circuit modules:

1. A dark sensor using two transistors
2. A dark sensor using NE555
3. A toggle switch using NE555

These three projects can be combined together to make a clap switch.
Full description is available on this page.
Make the project on your breadboard simply following the circuit layout given below:

clap-switch-with-monostable-and-toggle

Schematic
clap-switch-with-toggle-switch1

The full description of this project is available on this page.

Watch the following video also:




BUY A SIMPLE CLAP SWITCH ON MINIBREAD.COM

Comments

About This Instructable

9,414views

22favorites

License:

Bio: Hi, I am Sagar Sapkota. I am Electronics engineer living in Sydney, Australia. I love to work with electronic gadgets and build DIY kits. I ... More »
More by buildcircuit:NE555 and CD4017 Based LED Chaser With Photoresistor and Infrared SensorHow to Set Up Time and Alarm in C51 4 Bits Digital Electronic Clock DIY KitInfrared based music transmitter and receiver
Add instructable to: