A watering controller that can be home networked

Step 4 Programming the micro

After all of the parts have been mounted, load the code into the micro.

I use a FTDI USB-TTL cable for all of my Arduino programming work.  If you don't have a cable, you can use your Arduinoboard.  Simply unplug the micro from your board, plug in the ATMega328.  Program it as per normal, and then move the programmed chip into the sprinkler controller.

Easy!

Here is the code for the project as a PDE file.

Comments

[terys2]

Hi with what program i compile the .pde file .Thnx in advance

[drj113]

The .pde file is an Arduino sketch. It is designed to be loaded with the Arduino IDE.

[falk3n]

I hope you are good friends very well I think it's great your project but you could be q up the libraries that the program gives me error e downloaded these libraries appear and persist errors by

[drj113]

No problems - Which libraries do you need?

[diamantmatch]

hello again :)

can you upload the librarys to?
i dont have the lib for ds1302 and etherlib and stuff
thank you
diamantmatch