Print PDF
Favorite
Email
Step 9Close It all Up
Before all, you should secure the wires as shown in the picture with hot glue to reduce hassle. First, start with the top piece. (with the joystick) hold it upside down, so you are looking at the bottom of the joystick and your LED's. Now put the button back in and the spring back on. KEEP IT UPSIDE-DOWN!
Put the board back on the top half, STILL HELD UPSIDE-DOWN! Keep the right pins aligned with the right slots when putting it back on. While holding the board in place, put the bottom back on as shown in picture four. With the bottom back on, tighten the screws back up, and you're done!
Put the board back on the top half, STILL HELD UPSIDE-DOWN! Keep the right pins aligned with the right slots when putting it back on. While holding the board in place, put the bottom back on as shown in picture four. With the bottom back on, tighten the screws back up, and you're done!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
