AVR32 development board at home

This is my first instructable.So plz comment and help me out with any mistakes i might commit .
I have created a pcb for avr 32 ,its a development board .I saw that there none online with pcb that could be done at home so thought y not put it .     

To start with u need the basic concept of printing pcbs and itching them .
i find this link easy to learn http://www.riccibitti.com/pcb/pcb.htm.
And iam using eagle to create my pcb , an i think it can be improved .

Components Required
1. DC jack
2. 2amp bridge(KBP206g)or similare
3. push switch for power
4. cap(1000uf ,22pf-2)
5. regulators(7812,7805)
6. botton for reset
7. lot of male pins and female pins
8. 40pin dip socket or zip socket
9. led
10. resistor (100ohm, 1kohm)

bellow are pictures of the completed board.

Step 1

Lets get started
first to develop the board on eagle . That i have already done .
the one in the pictures is little diff from the one i put in eagle,i made some changes after a found some more requirements.
below is the pic of how the board looks on eagle.
i have uploaded the eagle .brb file which shows the complete details, and also a pdf file which can directly be printed.Be carefull while printing,see that the size is not altered and compare i.e. try placing components on printed paper before ironing it on to the board.

Comments

[aravindma1990]

cool! just replace these words jake=jack and itch=etch u dont want it to itch... u want to etch and can u mention how u connect this to the computer? like which pins and also which pins in the parallel port? thanks

[purus]

by connecting rs-232 cable we can connect