Introduction: Accelerometer Interfacing With Mediatek Linkit One Board

Picture of Accelerometer Interfacing With Mediatek Linkit One  Board

Today i will show how Mediatek Linkitone Board works with accellerometer ADXL335.

The ADXL335 is a small, thin, low power, complete 3-axis accelerometer
with signal conditioned voltage outputs. The product measures acceleration with a minimum full-scale range of ±3 g. It can measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion, shock, or vibration.

Step 1: Requirements

Picture of Requirements

ADXL 335

Accelerometer Sensor

Mediatek LinkIt One Board

Connecting Wires

Step 2: Connections

VCC : 3.3V

On Board

GND :Ground

X_OUT: A0

Y_OUT: A1

Z_OUT :A2

Step 3: Code,Compile and Run

Picture of Code,Compile and Run

Upload The Code And You are Ready To go!!!! You have succesfully made a friendship between ADXL335 and Linkit One Board...

Thanks For watching!!!! Have Fun!!!

Comments

About This Instructable

657views

4favorites

License:

More by Got007:Accelerometer Interfacing With Mediatek Linkit One  BoardFamous LM35 With Mediatek Linkit One BoardInterfacing Proximity Sensor With Mediatek Linkit One Board
Add instructable to: