Adventure Time's BMO: GBC Mod Replica

Step 2 Materials

Sorry I don't have the full layout of different parts and tools.  I sort of made him as I went along. 

Woo, a LOT of parts here.  Again, these will broken up into the different sections for Replica and Electronic.

Replica Parts

• 6 sheets of at least 1/16'' Plexiglass (measuring at least 4 1/2 '' by 6 inches)
• Thin, unflexible plastic sheet around 1/10 mm (at least 10'' by 5')
• Computer and printer
• at least two sheets of Turquoise Felt
• thin black thread and needle
• Cotton stuffing
• Mold Builder (Hey look, our old friend again!)
• Easy Cast Epoxy Resin
• Spruce of Blue 23-24 paint by Pratt and Lambertt ( or at least some kind of Blue-Green paint)
• Epoxy Glue
• several sheets of Photo Paper (not pictured)
• 6 small acrylic plastic pipes (around 2 1/2'' long)
• Sharpie Black Paint Pen (thin tip)
• Plastic red marker cap
• 2 clear acrylic containers (both 1 1/2'' wide) 
• Fine Tip Black whiteboard marker
• NES Controller (D Pad and button for casting)
• Game Cube Controller(A button for casting)
• Triangle Prism Papercraft
• Red, Yellow, and Sky Blue paint
• Beemo's Face jpg
   

Electronic Parts

• Spare Gameboy Color 
• Two plastic red button caps
• 6 small momentary push buttons (2 of which with long 1/2 inch buttons)
• 4 inches of 32 wire ribbon cable
• 7 inches of 8 wire shielded cable
• AA Battery Pack
• at least 12 inches of thin insulated wire
• at least 10 inches of flexible earphone/speaker wire
• 2 1'' diameter speaker
• Gameboy Advance Face Mask
• Jumbo Red LED (for additional fun)
• Small Circuit Board

Tools Used (not pictured, sorry)

• Hacksaw
• Soldering iron
• workbench vice
• Dremel tool
• Solder Pump or Wick (I prefer the former)
• Volt Meter (optional)
• Engraving Tool (optional)
• Metal Wood File
• Nintendo Game Boy Screwdriver
• Wire Cutters and strippers