Introduction: Air Blasters Double Shot Airsoft Hack!

This instructable will tell you how make your double shot gun to to fire
small bbs or even green rods from knex.

All you will need:
Nerf tm darts.
Air blaster's tm Double Shot
Shells for the gun.
A thick straw that just fits the shell.
(Must be able to fit a Nerf dart inside.)
bbs or small knex rods
Tape, scissors

Step 1: The Straw

Take your straw and place it into your shell, mark a line on
the straw where the shell ends. Cut around that line so
u have a tube about the same size as the shell.
If the straw is loose place some tape around the bottom.

Step 2: The Inner Tube.

Now take the nerf dart and pull out the rubber tip so you are left with
foam tube.

Step 3: Insert to the Outer Tube.

Simply push the smoother side of the modded dart into the
outer tubing until it reaches the other end.

Step 4: Sticking Them Together!

Take some more tape not to much and secure the inner and outer tubing
together. Remember to tape the side with the tape!
Then take the original shell and insert the straw into it
until you can't see the taped side.

Step 5: Loading and Firing!

Load the shells with the bbs or with simple knex pieces.
Then place inside the gun and fire away!

This hack allows the gun to shoot at least 20-30ft with knex green rods.
Sorry but I've ran out of bbs so I can't give any

Step 6: "UPDATE"

ding ding ding ding ding!!!!!!

In case you haven't really noticed you can use this mod on most air blasting

nerf guns!!!

Such as the Rapid fire tek

Bow gun thingy

NOT the tommy twenty duh

Maybe the maverick - Only do if ur prepared to stuff your gun ( freindly reminder)

and a few others definetly not the recon cs-6.

also try it on the others

Step 7: (UPDATED!)

New UPDATE ding ding ding dign "for those who are new to this instructable (using cool voice)
never cut off the white string ! And leave comments! (not really an update)

Step 8: UPDATE AS OF 23/2/10

Sadly as of a day or so ago the gun has fired its last shot ... and now um it's dead???


coolananias made it! (author)2013-06-20

how to make a bb gun out of a nerf gun 1cut the nerf dart bullet and cut the top and 2 have a pen and take it apart and throw away the enk and keep the pen tube and put the pen tube in the nerf bullet and tape the pen and the nerf bullet together and put the bullet in your nerf gun and put bb's in the nerf bullet and done

knexdude152 made it! (author)2009-01-24

omg i ordered this without enen knowing about this instructable! im going to use this when i get it if the range is s***

bendog38 made it! (author)bendog382011-05-24

The range is OK. The gun has some kick and the darts can sting from close range. I actually shot myself with it (I know, not a good idea) just to see how much power it has. I think that you are good with modifying the gun.

knexdude152 made it! (author)knexdude1522011-05-25

lol.........My comment: Jan 2009, your comment May 2011 urm yeah point said but i still have the gun and i have no use for it but i think i would just leave it as it is, for £12 it was fun :P

kittymeow made it! (author)kittymeow2009-04-21

the range is ok power is off charts

aj0my0lizard made it! (author)aj0my0lizard2011-02-23

you 2 stole my profile pic

guitarmonk15 made it! (author)guitarmonk152010-09-24

Hey! you stole my profile pick (just kidding).

knexdude152 made it! (author)knexdude1522010-09-29

haha lol i had never seen some1 with this pic but i was wrong lol hehe its been like a year since i have been on ibles lol tyvm for getting my fat bum back on this website... but no more nerf guns for i have found AIRSOFT i still have my nerf guns and i will sell them if any1 is interested... nerf raider, nerf recon, and a lanard rapid fire thing that uses a motor 60£ for the whole lot and 28£ each pickup in watford (england)

lukaj2003 made it! (author)lukaj20032009-08-11

NerfHaven have a mod for it, basically sawing off the barrel to the end of the grip (making it like a sawn-off shotgun) improves the distance my about 10-20 feet, makes it look cooler, makes it more compact and stops jams and stuff happening because the barrel is actually a little too wide for the darts and it loses too much air pressure.

Senior Waffleman made it! (author)2010-06-09

the rectange doesnt lead to the box in the box, once you get there, it goes to the bigger one

rbiernacki made it! (author)2009-08-14

my airsoft mod is way better. just take off the rubber tips, and find two airsoft barrels. stick the barrels into the dart and then into the shell. your shell must have all A.R.s out and be empty for this mod to work. mine shoots around 120 feet with .12 gram bbs

kenexinator made it! (author)kenexinator2009-09-22

hmm i was able to get a few thousand bbs and this works so much better now also i found out that the straw put more presure on the bb so i'd recomend that then using tape.

AJBrawlLvr made it! (author)AJBrawlLvr2010-03-20

I'm not sure, I was over at my friends house and his dad had a chronograph, so I measured mine with just duct tape and it went average of 127 FPS. Ill try the straw now

firefighter1333 made it! (author)firefighter13332009-09-20

rubber tips?

rbiernacki made it! (author)rbiernacki2009-09-22

the rubber tips from the darts

firefighter1333 made it! (author)firefighter13332009-09-23

oh btw could that mod also work for buzz bee rapid fire?

kenexinator made it! (author)kenexinator2009-09-24

Yep it works real good actually but you may not be able to use the clip-mag also if you have a nerf vulcan you need to try it!!!!!!!

firefighter1333 made it! (author)firefighter13332009-09-25

oh ok ty

Hellchild made it! (author)2009-10-16

I just bought one of those today. so paint it ans scare little kids with it(It looks GREAT) but i thought that little elastic string to hold it closed and stuff is the thng that cocks the gun. DONT CUT IT!!!!!! it makes the whole gun useless

kenexinator made it! (author)kenexinator2009-10-19

You cut the string ... ... ... ... ... ... ... ... ... .. ... ... ?

Hellchild made it! (author)Hellchild2009-10-20

yes. i cut the string

kenexinator made it! (author)kenexinator2009-10-22

you know what if you cept the gun and had some spae time you could just mod it and make some sorta bolt action ( pull action) gun thing only if youre bothered ... ... ... ... .... ....

Hellchild made it! (author)Hellchild2009-10-22

its too late for that now but i might buy another one. I sawed off the butt of the gun (the part with the ammo holder).
I like your idea, I just might to do that.

zimmemic25 made it! (author)2009-04-19

do i need the straw only to keep the dart from flying away? if yes, you can also put this silver tape (which have these net texture) on the dart, it will also stick in the barrel.

kenexinator made it! (author)kenexinator2009-09-28

The straw keeps it extra pressured-really pressured ... it took me a while to get back.

kenexinator made it! (author)2009-04-27


Gamer917 made it! (author)Gamer9172009-08-05

i see u got a crappy wookie bowcaster toy there

K.S.E made it! (author)K.S.E2009-07-23

I saw that at dick's sporting goods plus a a regular bow that uses nerf darts or somtin like that

Landon Sullivan made it! (author)Landon Sullivan2009-04-28

O.O I like it. The Ultimate foam-shooting Wookie crossbow of death.

nike3000av made it! (author)2009-07-31

dude if u what t make the longshot nerf gun shot the darts just pull the triger back all the way after you load the gun good job dud make more videos see you

naruto the ninja13 made it! (author)2009-06-16

what dose th middle sat?

kenexinator made it! (author)kenexinator2009-06-24

The middle line is just to show u that the box near my arm is wat the middle is OK? And where do u live because in syney we got a shop called gumballs and they give us HUGE straws.

naruto the ninja13 made it! (author)2009-06-16

were do you get straws big enough to fuit a nerf dart in

kenexinator made it! (author)2009-04-27

Well I did the mod with this gun it works so much better really. But I'm not sure they still sell it.

kenexinator made it! (author)2009-04-27

And really I'm not so sure why I placed a straw around it. Probably because when I placed Knex peices inside it, it deforms. But the straw sorta retains it.

kenexinator made it! (author)2009-04-24

Well, this "mod?" really works on all different types of dart firing guns so you could probably get something good out of something else.

kenexinator made it! (author)2009-01-24

I actually found a bb and fired it a couple of times. It actually hurts at point blank range. By the way this is my first instructable

meanbean made it! (author)meanbean2009-04-04

Y not just buy bbs?

firebird11692 made it! (author)2009-02-22

I modded this gun for Airsoft. it works awesome and shoots 3 bbs with each shot.

xdarkxsparkyx made it! (author)xdarkxsparkyx2009-03-10

nice mine could shoot the hole load oh and mine could shoot almost every thing like rocks its cool

knexdude152 made it! (author)2009-01-28

mine broke after a few minutes now im sending it back to the sellers

Vynash made it! (author)2009-01-23

Good job! My friend has this thing and it's really a flimsy kind of plastic. And I don't like how it works sorta.

amtdude made it! (author)amtdude2009-01-24

actualy its your friends brother.

About This Instructable




More by kenexinator:KNEX HIDDEN GUN WITH SHELLSAir blasters Double shot airsoft hack!
Add instructable to: