Introduction: Airsoft Speed Loader

This is an airsoft speedloader that actually works well.

Step 1: Materials

You will need scissors, tape, a plastic cup, bb's, and a pen tube

Step 2: Tape Tape Tape!

Tape half of the top of the cup, but make sure you put tape on both sides so no BB's get stuck when pouring.  then load it up

Step 3: Holes

Pierce a hole in the tape near the edge and stuff the pen tube through

Step 4:

When using the loader jiggle the tube up and down to make it load faster. 
THIS THING LOADS AT AN AVERAGE OF 460 BB'S PER MINUTE REALLY FAST, WATCH MY YOUTUBE VID TO SEE HOW WELL IT WORKS.
http://www.youtube.com/watch?v=5fyHFaQSnnU

Comments

author
ilpug (author)2011-09-28

this is a funnel.

author
Chowmix12 (author)2011-04-28

This isn't a speed loader, it's a tube loader...

author
create#1 (author)2010-11-09

if u can make it a little smaller and stronger it would be alot better but its a good start

author
Landon Sullivan (author)2009-10-25

woot.
Who wants to actually carry this with them? Just buy some midcaps or hicaps.

author

or simply buy a drum mag and not need to reload.

author
alexgator99 (author)2009-11-03

ok i watced the youtube videos. biggest flaw with this is that it wouldnt have the pressure to load a clip

author
Kaelessin (author)alexgator992009-11-10

That's true but some mags have a way to hold the spring back and then just pour bb's in.

author
mitchell12 (author)2009-10-25

Screw hi-caps. Get a REAL speed loader and some low or mid caps.

About This Instructable

8,015views

11favorites

License:

More by chardlz13:AEG Gearbox takedownAirsoft Speed loaderAirsoft Holster
Add instructable to: