Print PDF
Favorite
Email
Step 2Step One: Setting It Up
1. Make a hole in the front of the Altoids container just big enough so the phototransistor can fit through and stick out.
2. Put all of the components into the holes of the PC Board, evenly spaced, but only taking up half of the board. Make sure the Phototransistor is in the middle of the front of the board, so it can stick out the hole int the Altoids container.
2. Put all of the components into the holes of the PC Board, evenly spaced, but only taking up half of the board. Make sure the Phototransistor is in the middle of the front of the board, so it can stick out the hole int the Altoids container.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
