Print PDF
Favorite
Email
Step 10Attach Remaining Resistors to Middle Tab (Right Channel)
1) attach a resistor to the middle tab of the next input jack
- solder & trim excess wire
2) wrap the other lead of the resistor around the lead of the resistor in the previous stage (see photo),
- make sure that this end has a direct electrical connection to the middle tab of the output jack.
- solder and trim excess wire.
3) Repeat until all input jacks have their middle tab tied to the output middle tab through a resistor
4) After attaching all resistors to middle tabs (right channel), gently bend the entire string down slightly to make room for the left channel resistors.
Hint: Do the connecting, soldering and trimming of each resistor one stage at a time, this will be a lot easier than fitting and soldering all inputs at once.
- solder & trim excess wire
2) wrap the other lead of the resistor around the lead of the resistor in the previous stage (see photo),
- make sure that this end has a direct electrical connection to the middle tab of the output jack.
- solder and trim excess wire.
3) Repeat until all input jacks have their middle tab tied to the output middle tab through a resistor
4) After attaching all resistors to middle tabs (right channel), gently bend the entire string down slightly to make room for the left channel resistors.
Hint: Do the connecting, soldering and trimming of each resistor one stage at a time, this will be a lot easier than fitting and soldering all inputs at once.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
