Print PDF
Favorite
Email
Step 5Drill 1/4" Holes and Clean Ragged Edges
Drill each hole with a 1/4 drill bit. Again, a small piece of wood behind the metal will keep it from bending and make the backside of the holes neater.
Carefully clean up the ragged edges of the holes with the side cutters or a sharp knife like an exacto hobby knife. This is important so the jacks sit flush.
Hint: As always, safety first, follow this rule: never put anything in front of a sharp blade that you don't want to cut!
Carefully clean up the ragged edges of the holes with the side cutters or a sharp knife like an exacto hobby knife. This is important so the jacks sit flush.
Hint: As always, safety first, follow this rule: never put anything in front of a sharp blade that you don't want to cut!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
