Instructables

Altoids Tin Speaker

Step 11: Installing Additional Parts

Picture of Installing Additional Parts
ats-install-02.jpg
ats-install-03.jpg
ats-install-04.jpg
Cut the leads of the external parts to length one at a time by fitting the board into the tin and placing the part over it. Too long is better than too short. Solder them into place in the following order -- switch, audio jack, battery holder, speaker.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!