With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
share what you made with text, photos, video, and files
gather your favorite instructables together
This is a small quick project I use in my after school Engineering club for Yr9 students (13year olds). As with all my instructables its achievable by...
A working drawing is a 2D drawing that shows you the dimensions needed to make a product or component.
Put your work piece (Ø12mm aluminium rod) into the lathe chuck You should have approximately 50mm sticking out the chuck You must never l...
• Centre drill the end
• Drill Ø4mm x 15mm deep
Sand outer surface Be very careful not to touch the spinning chuck with your fingers
Set the cutting tool to the correct angle Decide where the first groove will be Advance the tool forward to create the first cut, it sho...
Set the parting off tool to exactly 900 Part off
Set the parting off tool to 450 Create a chamfer on both ends
Decide how long you want the cable to be (mine was 80mm) Use wire cutters to cut cable
Mix a pea sized blob of epoxy resin and carefully put into the hole Fold the cable over and put the ends into the hole
Roll on the o-rings Enjoy :)
Glow in the dark keyringby jonnyd55
Aluminum Captive Ring on Barby Nikkio101
How to fit a saddle stop to a latheby MyHobbyStore
12V Solenoid Beam Engine, built from aluminium scraps and scavanged componants.by Dr Qui
Miniature Radial Engine Crank Caseby Flying_MashedPotatoes
How to Repair a Lawn Mower Engine.by Sedgewick17
Phone / Ipod holderby jonnyd55
Air Engineby jonnyd55
How to fit a digital readout to a latheby MyHobbyStore
How to Build a Jet Engine!by fozzy13
Download our new apps for iOS, Android and Windows 8!
© 2014 Autodesk, Inc.
By clicking "Create Account" you are indicating that you have read and agree to the Terms of service.
Already a member? Login »
Enter the email associated with your account and we will send you your username and a temporary password.
Not a member? Sign Up »