With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
This is a small quick project I use in my after school Engineering club for Yr9 students (13year olds). As with all my instructables its achievable by...
A working drawing is a 2D drawing that shows you the dimensions needed to make a product or component.
Put your work piece (Ø12mm aluminium rod) into the lathe chuck You should have approximately 50mm sticking out the chuck You must never l...
• Centre drill the end
• Drill Ø4mm x 15mm deep
Sand outer surface Be very careful not to touch the spinning chuck with your fingers
Set the cutting tool to the correct angle Decide where the first groove will be Advance the tool forward to create the first cut, it sho...
Set the parting off tool to exactly 900 Part off
Set the parting off tool to 450 Create a chamfer on both ends
Decide how long you want the cable to be (mine was 80mm) Use wire cutters to cut cable
Mix a pea sized blob of epoxy resin and carefully put into the hole Fold the cable over and put the ends into the hole
Roll on the o-rings Enjoy :)
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »