Step 8: Assembly
Take the Burn Bowl from step 4 and remove material from the small end of the neck as necessary, until the neck is short enough to allow the tapered portion to fit tightly in the hole of the Jet Deck.
It should be a tight force fit without gaps. Also the narrow end of the Burn Bowl neck should be touching the bottom of the Base so do not remove too much material at once.
It should be a tight force fit without gaps. Also the narrow end of the Burn Bowl neck should be touching the bottom of the Base so do not remove too much material at once.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
acoleman3
says:
Jul 7, 2011. 10:47 AMReply
out of curiosity, why is it tht the mouth of the neck needs to touch the bottom.
JoshuaSmock
in reply to Jul 28, 2011. 10:59 AMReply
Most likely for compression to aid in the evaporation of fuel.
Visit Our Store »
Go Pro Today »
